Introduction
This guide shows how to remove the 5G mmWave antenna in your Google Pixel 9 Pro XL.
Ce dont vous avez besoin
-
-
Adhesive secures the perimeter of the rear cover to the frame.
-
-
-
Attach a suction handle to the bottom edge of the rear cover, as close to the edge as possible.
-
-
-
Pull up on the suction handle with strong, steady force to create a small gap under the rear cover.
-
Insert the tip of an opening pick in the gap.
-
-
-
Slide your opening along the bottom edge to separate the adhesive securing it.
-
-
-
Use the suction handle to lift the left edge of the rear cover and swing it over the right edge, like opening the cover of a book.
-
Prop up the rear cover with the suction handle so you can access the ribbon cable near the top right corner.
-
-
-
Use a Torx Plus 3IP screwdriver to remove the two 5.2 mm‑long screws securing the cable cover.
-
-
-
-
Use the point of a spudger to pry up and disconnect the rear cover press connector.
-
-
-
Use the tip of a spudger and your fingers to peel up the piece of tape near the left edge of your phone, enough that you can access the bracket and screws underneath.
-
-
-
Use a Torx Plus 3IP screwdriver to remove the two 5.2 mm‑long screws securing the wireless charging cable cover.
-
-
-
Use the tip of an opening pick to pry up and disconnect the wireless charging press‑connector.
-
-
-
Use a Torx Plus 3IP screwdriver to remove the two 2.2 mm‑long screw securing the wireless charging assembly.
-
-
-
Use a spudger to pry up and disconnect the battery press connector.
-
-
-
Use a Torx Plus 3IP screwdriver to remove the 5.2 mm‑long screw securing the mmWave antenna cover.
-
-
-
Insert the point of a spudger under the tab near the bottom left corner of the mmWave antenna cover.
-
Use your spudger to slide the cover to the right while prying up to unclip the cover.
-
-
-
Use the point of a spudger to pry up and disconnect the mmWave antenna press connector from the top right corner of the logic board.
-
-
-
Use the point of a spudger to pry up and disconnect the front facing camera press connector.
-
-
-
Carefully hold the front facing camera cable out of the way so you can access the mmWave antenna screw.
-
Use a Torx Plus 3IP screwdriver to remove the 4.2 mm‑long screw securing the mmWave antenna.
-
-
-
Use tweezers or your fingers to remove the mmWave antenna.
-
